Tire Pressure Monitoring Control Module -J502-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Different installation positions:
- Version 1: at the center rear subframe.
- Version 2: at the left rear tank aerodynamic trim bracket.
- Version 3: at the left rear level sensor.
-- Release the retainer -arrow-, disengage the Tire Pressure Monitoring Control Module -J502- -item 1- from the subframe and remove (example illustration).
-- Disconnect the connector -2- (example illustration).
-- Release the catch -arrow- and remove the Tire Pressure Monitoring Control Module - J502- -item 1- toward the rear (example illustration).