Rear Axle Camber, Adjusting

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Fine tooth ratchet, commercially available

Procedure

Courtesy of AUDI

-- Remove the nut -1- for the threaded connection between the subframe/lower rear transverse link. Install a new nut all the way.

-- Adjust the camber by rotating the adjusting bolt -2-.

TIP:

To turn the adjusting screw, turn the hex head at the >>top of the screw<<.

Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
The maximum adjustment range is 135° to left or right of center position.
Do not rotate the adjusting bolt -2- further once the end position has been reached or the components will be damaged.
For clarity the rear wheel is not shown.

-- Tighten the nut -1-.

-- Then check the camber value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .

Tightening Specifications

Refer to OVERVIEW - TRANSVERSE LINK