Front Axle Toe, Adjusting

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2-. Note the value. Dimension -a- should be the same before and after adjusting on the left and right.

Fig 1: Measuring Tie Rod Head / Tie Rod Dimension

Courtesy of AUDI

-- Loosen the lock nut -B- by counterholding the tie rod end -C-.

Fig 2: Locating Lock Nut

Courtesy of AUDI

-- Adjust the toe respectively at the left and right wheel with the hex fitting -A-.

CAUTION:

There is a risk of premature wear if the boot is twisted.

- Make sure the boot is not twisted when it is installed.

-- Tighten the lock nut -B-, OVERVIEW - STEERING GEAR, TIE RODS and check toe-in value again.

TIP:

After tightening the lock nut -B-, it is possible that the value will deviate slightly.
However, if the measured toe value lies within the tolerance, the adjustment is correct.