General Information - Name Badges And Emblems, Replacing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Roller :3356
- Cleaning Solution :D 009 401 04
- Applicator :D 009 500 25
- Bonding Agent :D 355 205A2
- Loosened name badges and emblems must be replaced.
- The vehicle as well as the name badges and emblems must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent :D 355 205A2 dries longer than 3 hours, then it must be primed again.
-- Clean the adhesive surfaces using Cleaning Solution :D 009 401 04 .
-- Apply Bonding Agent :D 355 205A2 on the adhesive surface using the Applicator :D 009 500 25 and let dry.
-- Warm the adhesive areas to approximately 40 °C (104 °F) using a hot air blower.
- Neighboring components must be protected against temperature effects.
-- After successfully assembling, press on the emblems again with the roller.