General Information
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Improper handling increases the risk of damaging the threads in the vehicle body.
- Never use an impact wrench to loosen or tighten.
- Position the bolts by hand only and screw in the first threads.
- When installing waxed components, contact surfaces must be cleaned. Contact surfaces must be free of wax and grease.
- Welding or adjustment procedures are not permitted on load-bearing or wheel-controlling components.
- Avoid hammering, welding beads or applying color identification later to coil springs.
- Do not perform any welding or grinding (separating work) near the coil springs or suspension struts. Cover coil springs or suspension struts if necessary.
- When loosening or removing and installing hydraulic, pneumatic lines or wires, draw sketches or take pictures. This ensures installation is the same as the original.
- If the cable ties, brackets or mounting elements were removed during the repair procedure, they must be installed at their original location that corresponds to the series production.
- Apply a thin coat of assembly paste to the splines on the outer joint before installing the outer joint in the wheel hub. Refer to the appropriate Electronic Parts Information.
- Never allow the drive axle to hang loose under the vehicle or to bend them at the joints during repair procedures.
- Vehicles without a drive axle must not be moved, otherwise the wheel bearing will be damaged. If a vehicle must be moved, be sure to note the following:
- Install an outer joint in place of the drive axle.
- Tighten the outer joint to 200 Nm.
- Bonded rubber bushings have a limited range of rotation. Only tighten the suspension bolts when the vehicle is in curb weight position or at standard vehicle height.
- Lifting the wheel bearing in curb weight position (refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING ) or at standard vehicle height (refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION ).
- Always replace bonded rubber bushings on both sides of vehicle.
- If the vehicle must still have an axle alignment, only tighten the bolts and nuts that were loosened when making adjustments to the tightening specification. Tighten the bolts and nuts to the specified additional tightening angle after the alignment/adjustment is complete.
CAUTION:
There is a risk of accident due to threaded connections that are not tightened correctly.
- Tighten threaded connections correctly before driving on public roads.