Left Rear Parallel Parking Assistance Sensor -G716- /Right Rear Parallel Parking Assistance Sensor -G717-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear wheel cover. Refer to the appropriate Service Information .
-- Loosen the rear wheel housing liner in the area of the bumper and underbody trim panel. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Remove the bolts -1-.
-- Disengage the bumper cover side piece -2- from the side panel outward in direction of -arrow-.
-- Press both tabs in direction of -arrows- to the side and press the sensor -1- inward from the outside.
-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.