Guidelines For Clean Working Conditions
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Even small pieces of debris can cause faults. That is why the following guidelines for clean working conditions must be ensured with all procedures:
- Clean the connection points and the area around them prior to loosening.
- Clean with lint-free cloths.
- Immediately seal off any open lines and connections with clean plugs, for example, taken from the Engine Bung Set -VAS 6122-.
- Refrigerant circuit components must immediately be sealed with plugs taken from the Engine Bung Set -VAS 6122- after opening.
- Place removed parts on a clean surface and cover them with lint-free cloths.
- Carefully cover or seal opened components if repairs are not performed immediately.
- Immediately remove leaking liquids and clean the affected areas.
- Only install clean parts: remove the replacement parts from their packaging just before installing them. Do not use components which were stored without packaging.
- Protect the disconnected electrical or optical connectors from dirt and moisture and only connect when they are dry.