Starter, Removing And Installing, Vehicles With 3.0L TFSI Engine: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable to the Battery -A- when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING .

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI

-- Remove the bolt -5- and the nut -4-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI

-- Remove the starter -1-, disconnect the connector -3- and free up the B+ wire -2-.