General Information

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Risk of injury. Follow all warning messages and safety precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .

It is not necessary to disconnect or remove the Battery -A- when using the Battery Tester with Printer :VAS5097A :VAS5097A .

The following Batteries -A- can be tested using the Battery Tester with Printer :VAS5097A :

80 to 499 A cold crank amps according to German Industry Standardization DIN (Deutsche Industrie Norm). Refer to GENERAL INFORMATION.
95 to 574 A cold cranking output according to IEC (International Engineering Consortium)
136 to 855 A cold cranking output according to EN/ SAE (Europαische Norm/ Standard of Automotive Engineers)

Batteries -A- with cold crank amps greater than 499 A according to DIN can be tested with the setting for 499 A according to DIN.

The Batteries -A- are tested by being loaded with current that corresponds to the starter current of a vehicle. Under this load, the Battery -A- is evaluated and the measured results are output through the printer.

NOTE:

Read the Battery Tester with Printer :VAS5097A Operating Instructions and Battery Tester with Printer :VAS5097A Quick Reference Guide label on the Battery Tester with Printer :VAS5097A and the cold crank amps table. Refer to COLD CRANK AMPS TABLE .

Battery Tester with Printer :VAS5097A device description. Refer to Battery Tester with Printer .
Battery load test. Refer to BATTERY LOAD TEST .
Cold crank amps table. Refer to COLD CRANK AMPS TABLE .
Battery load test results. Refer to BATTERY LOAD TEST RESULTS .
Printed test results explanations. Refer to PRINTED TEST RESULTS EXPLANATIONS .
Test result evaluation. Refer to TEST RESULT EVALUATION .