Drivetrain Control Module -J775-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Drivetrain Control Module -J775- is replaced, select the "Control module, replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the center console trim panels. Refer to OVERVIEW - CENTER CONSOLE ; Overview - Center Console, Support/Cover.
-- Disconnect the connector -2-.
-- Remove the left and right nuts -arrows- and remove the Drivetrain Control Module -J775-.