Molded Foam Part, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

Risk of damaging the pressure hose by deforming it.

- Never kink or stretch the pressure hose.

For Pressure Hoses with a Color Marking:

Courtesy of AUDI

-- Position the pressure hose -2- at the center of the color mark -4- in the recess at the specified marking -3- in the molded foam part -1-.

For Pressure Hoses without a Color Marking:

-- Measure out and mark the center of the pressure hose.

-- Position the pressure hose evenly in both directions -arrows- in the recess in the molded foam part.

Continuation:

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Engage the pedestrian protection crash sensor -5- into the molded foam part.

-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.

Connector Lock on Pedestrian Protection Crash Sensor

Fig 1: Identifying Connector

Courtesy of AUDI

-- Push in the connector lock -2- to secure the connector.