ADDITIONAL WORK AFTER REPLACING Differential Lock Control Module -J187-

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Only perform the additional work only if the Differential Lock Control Module -J187- was replaced.

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 32 - Replacing Control Module on the Vehicle Diagnostic Tester under Guided Functions in the directory 32- Locking Electronics .

Follow all the instructions given by the Vehicle Diagnostic Tester exactly.

The installed rear final drive is "adapted" to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester.

A system check will take place when the 32 - Control Module, Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.