Input Shaft Seal, Replacing, 0DG: Notes

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Piece - Multiple Use:VW 431

Courtesy of AUDI
Puller - Unit Injector:T10055

Fig 1: Identifying Puller T10055
Courtesy of AUDI
-2- Puller - Unit Injector - Adapter 2:T10055/2
Thrust washer from Seal Installer - Rear Crankshaft:T10134

Fig 2: Identifying Seal Installer - Rear Crankshaft
Courtesy of AUDI
Seal Installer - Hollow Shaft:T10380

Fig 3: Identifying Thrust Piece - T10380-
Courtesy of AUDI
Seal Installer - Shaft Seal:T10432

Fig 4: Identifying Assembly Tool T10432
Courtesy of AUDI
-1- Two-Arm Puller:VAS251001

Fig 5: Identifying Special Tools - Kukko 20/10 Puller Set
Courtesy of AUDI
Inductive Heater:VAS 6414

Fig 6: Identifying Inductive Heater VAS 6414
Courtesy of AUDI
or
Commercially Available Hotplate with Digital Thermometer:VAS 6519

Fig 7: Identifying Digital Thermometer VAS 6519
Courtesy of AUDI
Used Oil Collection and Extraction Unit:SMN372500

Fig 8: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI
Sealing Grease:G 052 128 A1