Flange/Driveshaft Protective Ring, Replacing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate:VW 401

Fig 1: Press Plate
Courtesy of AUDI
Press Piece - Rod:VW 407

Courtesy of AUDI
Press Piece - Multiple Use:VW 412

Fig 2: Identifying Press Piece - Multiple Use VW412
Courtesy of AUDI
Seal Installer - Flange Shaft:T10049

Courtesy of AUDI
-3- 22 to 75 mm Separating Tool, for example Splitter:VAS251411

Fig 3: Commercially Available Puller Set
Courtesy of AUDI

Flange/driveshaft removed.

Press the protective ring off the flange/driveshaft.

Fig 4: Pressing Dust Cap Off Of Driveshaft Flange

Courtesy of AUDI

A -

22 to 115 mm Separating Tool, for example Splitter:VAS251411

Install the protective ring arrow onto the flange/driveshaft.

Fig 5: Install the protective ring -arrow- onto the flange/driveshaft.

Courtesy of AUDI

Installation position: ribbed side of the protective ring points to the flange.
The protective ring -A- must engage audibly in the groove on the flange.