Bumper Cover Side End Panel, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Drill out the pop rivet heads -1- and pierce the rivet shaft.
-- If equipped, release and disconnect the connectors -3-.
-- If equipped, remove the front parallel parking assist sensors. Refer to LEFT FRONT PARALLEL PARKING ASSISTANCE SENSOR -G568- /RIGHT FRONT PARALLEL PARKING ASSISTANCE SENSOR -G569-, REMOVING AND INSTALLING .
-- Free up the wiring harness -7- at the end panel -2-.
-- Remove the bolts -4-.
-- RS Q8: Release retainers -5 and 6-.
-- Remove the side end panel -2- from the bumper cover.