Brake Pad Wear Indicator Wire, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Check the brake pad wear indicator contact for damage and replace if necessary.
- Make sure that the brake pad wear indicator contact fits correctly in the brake pad.
-- Insert the contact -3- for the brake pad wear indicator with the clip -4- until it engages in the inner brake pad.
-- Secure the brake pad wear indicator wire with the dust cap -2- and the clips -1 and 5-.
-- Bring the connector -1- into its installation position and turn in the direction of -arrow- until the tab -3- engages in the hole -4- on the bracket.
-- Connect the connector -2-.
- Make sure that the wire is routed correctly.
- Make sure the wire is not blocked, bent, or rubbing against the vehicle.