Overview - Attachments For Heater And A/C Unit And Air Intake Housing, Pr Number 9AH/ 9AQ
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Double Bolt
- Air Duct
- With recirculation doors and various levers
- Removing and Installing. Refer to Rear Fresh Air Blower -V80-, REMOVING AND INSTALLING .
- Nut
- 20 Nm
- Rear Fresh Air Blower -V80-
- Ensure the correct allocation. Refer to the Parts Information.
- Removing and Installing. Refer to Rear Fresh Air Blower -V80-, REMOVING AND INSTALLING .
- Coolant Supply Line
- Integration of A/C system into coolant circuit. Refer to REAR HEATING AND A/C SYSTEM, INCORPORATION IN THE COOLANT CIRCUIT, "High" A/C SYSTEM .
- Removing and Installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Coolant Return Line
- Incorporating the Heating and A/C System in the Coolant Circuit. Refer to REAR HEATING AND A/C SYSTEM, INCORPORATION IN THE COOLANT CIRCUIT, "High" A/C SYSTEM .
- Removing and Installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Bracket for Coolant Pipes
- Removed during removal of the heater and A/C unit (so that the heater core can be removed). Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING, "High" A/C SYSTEM, PR NUMBER 9AH/ 9AQ .
- Bolt
- 2 Nm
- Screw-Type Clamp
- Replace after removing. Refer to the Parts Information.
- Removing and installing on the heater core. Refer to HEATER CORE, REMOVING AND INSTALLING .
- 2 Nm
- O-Ring
- Replace after removing. Refer to the Parts Information.
- Lubricate lightly with coolant before installation.
- Screw-Type Clamp
- Replace after removing. Refer to the Parts Information.
- Removing and installing on the heater core. Refer to HEATER CORE, REMOVING AND INSTALLING .
- 2 Nm
- O-Ring
- Replace after removing. Refer to the Parts Information.
- Lubricate lightly with coolant before installation.
- Rear Heater Core
- The bonded foam seal must not be damaged and must be bonded
- Removing and Installing. Refer to HEATER CORE, REMOVING AND INSTALLING .
- Air Intake Housing Upper Section
- Removing and Installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING, "High" A/C SYSTEM, PR NUMBER 9AH/ 9AQ .
- Evaporator (with Refrigerant Lines)
- Check the glued-on foam seal. It must not be damaged and must be properly bonded
- Removing and Installing. Refer to EVAPORATOR, REMOVING AND INSTALLING .
- Air Intake Housing Lower Section
- Removing and Installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING, "High" A/C SYSTEM, PR NUMBER 9AH/ 9AQ .
- Foam Seal
- Pushed on the condensation water drain and on the rear fresh air blower drain
- Bolt
- Quantity: 9
- 2 Nm
- Rear Fresh Air Blower Control Module -J391-
- Ensure the correct allocation. Refer to the Parts Information.
- Removing and Installing. Refer to Rear Fresh Air Blower Control Module -J391-, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- 2 Nm