Left Rear Air Distribution Motor -V593-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of damaging the adjustment motor electronics when turning the mount.

- Turn the adjustment motor mount only when the wiring harness is connected.

- Install the mount carefully and slowly by hand.

The actuator mount does not have a stop. It turns constantly if the actuator is activated. Therefore, it should not be activated when the actuator is removed.
Check the connection between the actuator mount and the shaft; there must not be any play.

-- Check the shaft -A- and the mount -B- for the actuator -C-. They must be properly aligned so that they can be joined.

-- Attach the actuator mount -B- to the door shaft -A-.

-- Connect the connector -C-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -A-.

-- Route the wiring harness to the connector -C- so that it cannot come in contact with any moving parts.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES FOR REMOVING AND INSTALLING ADJUSTMENT MOTORS .

Tightening Specification

Refer to OVERVIEW - FRONT ADJUSTMENT MOTORS, PR NUMBER 9AE/ 9AQ/ 9AU, LHD