LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Hood, Lids (Fy)) >> 55 Hood, Lids >> Rear Lid >> Striker, Removing And Installing >> Removing

Striker, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Mark the installation position for reinstallation.

-- Remove the nuts -1 and 3- and remove the striker -2-.

Fig 1: Identifying Combination Nuts -1- And -3-, Striker Pin -2-
GWWA55-10449Courtesy of AUDI