Rear Lid Seal, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the rear lid seal on the body flange in the sequence: -1, 2 and 3-.
-- Align the mark -A- on the rear lid seal to the center roof frame seal hole and attach.
-- Attach the left and right rear lid seal downward to -item C-.
-- Align the rear lid seal with the butt joint -A- to the striker and attach.
-- Attach the left and right rear lid seal upward through -item B-.
-- Press on the entire length of the rear lid seal.