Hood, Removing And Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- To complete the procedure, a second technician is required to be at the following position. Refer to HOOD, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the hood by opening when the pedestrian protection is triggered
- Only open the hood after the triggered pedestrian protection has been reset.
- Removed pedestrian protection: hinge is reset. Refer to HINGE, RESETTING .
-- Remove the washer nozzles. Refer to WASHER NOZZLES, REMOVING AND INSTALLING .
-- Remove the grommet -2-.
-- Guide out and free up the wiring harness -1- and washer fluid hose -3- from the hood.
-- Mark the installation position of the hinge on the hood.
-- Remove the gas-filled strut from the hinge. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
-- Remove the nuts -arrows- from the hinge.
-- Remove the front lid.
Installing
Install in reverse order of removal and note the following:
-- Adjust the hood. Refer to HOOD, ADJUSTING .
Tightening Specifications
- Refer to OVERVIEW - HOOD