Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, ADVANCED SOUND SYSTEM (8RF), THROUGH MY 2020: Removing

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the interior partition cover. Refer to COMPONENT LOCATION OVERVIEW - VEHICLE INTERIOR TRIM PANELS .

The bracket -2- with the Digital Sound System Control Module -J525- -1- must be removed first.

-- Remove the nuts -arrows- from the bracket -2-.

Courtesy of AUDI

-- Pivot out the bracket -2- with the Digital Sound System Control Module -J525- -1-.

-- Release and disconnect the connectors -3- from the Digital Sound System Control Module -J525- -1-.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9  -1- onto the MOST bus connector -2-.

Courtesy of AUDI

-- Remove the bolts -3- from the bracket -2- and remove the Digital Sound System Control Module -J525- -1- from the bracket.

Courtesy of AUDI