Control Module for Emergency Call Module and Communication Unit -J949-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the right front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Lift the front carpet at the transition to the rear carpet.
The Control Module for Emergency Call Module and Communication Unit -J949- is clipped into the bracket.
-- Push the retainers in the direction of -arrow B-
-- Remove the Control Module for Emergency Call Module and Communication Unit -J949- -1- from the bracket -2-.
-- Release and disconnect the connectors -3-.
Bracket, Removing
-- Remove the wiring harness from the bracket -2-.
-- Remove the nut -arrow A-.
-- Pull the bracket -2- off the threaded pin and remove it rearward from the body.