LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Communication) >> 91 Communication >> Antenna Systems >> Traffic Data Antenna, Removing And Installing >> Removing

Traffic Data Antenna, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The connectors -1- for the Traffic Data Antenna -R173- are located on the roof crossmember, behind the left sun visor. The flat band cable -2- is routed on the roof crossmember. The headliner must be removed, to remove.

Fig 1: Identifying Connectors Of Traffic Data Antenna
GWWA91-11898Courtesy of AUDI

-- Lower the headliner. Refer to OVERVIEW - HEADLINER .

Fig 2: Identifying Connectors Of Traffic Data Antenna
GWWA91-11898Courtesy of AUDI

-- Release and disconnect the connector -1-.

Traffic Data Antenna -R173- removal:

A securing piece -2- secures the Traffic Data Antenna -R173- -1- in its bracket -3-. The bracket is glued to the windshield -3-.

Fig 3: Identifying Safety Piece
GWWA91-11791Courtesy of AUDI

-- Remove the safety piece -2- with a small screwdriver.

Fig 4: Identifying Safety Piece
GWWA91-11791Courtesy of AUDI

-- Remove the Traffic Data Antenna -R173- -1- from the bracket -3-.