Rear Sill Panel, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Before installing, check all the fasteners for damage and replace if necessary.

-- Insert the clips -2- into the body before assembly.

-- Remove any remaining clips in the body using the Omega Clip Tool:T40280 and insert in the trim panel for installation.

-- Check that the door seal is correctly positioned after installing.