LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Trim Panels And Insulation) >> 70 Trim Panels And Insulation >> Vehicle Interior Trim Panels >> D-Pillar Trim Panel, Removing And Installing >> Removing

D-Pillar Trim Panel, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
GWWA70-13050Courtesy of AUDI

-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Pry out the trim -1- with the scraper -2- in the direction of -arrow A-.

-- Remove the trim -1- in the direction of -arrow B-.

-- Remove the expanding rivets -2- with scraper no. 4.

GWWA70-13051Courtesy of AUDI

-- Unclip the cover -1- and remove in the direction of -arrow-.

-- Clean the scraper -2- thoroughly as to not contaminate the headliner.

GWWA70-13052Courtesy of AUDI

-- Pry out the trim -1- with the scraper -2- in direction of -A arrows-.

-- Unclip the trim -1- and remove in the direction of -arrow B-.

-- Remove the bolts -3 and 4-.

GWWA68-11162Courtesy of AUDI

-- Only loosen the nut -2-.

-- Turn the luggage compartment cover rail -1- so that the D-pillar trim panel is accessible.

-- Free up the D-pillar trim panel -1- in the rear lid seal area.

GWWA70-13053Courtesy of AUDI

-- Pull the D-pillar trim panel -1- carefully off the body mounts in direction of -arrows- and remove.