B-Pillar Upper Trim Panel, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Before installing, check all the fasteners for damage and replace if necessary.
-- Remove any remaining clips in the body using the Omega Clip Tool:T40280 and insert in the trim panel for installation.
- Do not pinch the head curtain airbag when installing the B-pillar upper trim panel.
-- Guide the seat belt webbing with the belt tongue in through the belt height adjuster slider.
-- Make sure that the belt height adjuster is in the lowest position.
-- First, insert the B-pillar trim panel upward into the mount on the roof.
- The retaining pin -1- for the sliding piece on the B-pillar trim panel must engage in the mount -2- on the seat belt height adjuster -arrow-.
Further installation is performed in reverse order of the removal.
-- Check that the door seals are correctly positioned after installing.