Center Differential, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the center differential housing O-ring.
If the center differential -1- was removed:
-- Position the center differential on the input shaft splines. Rotate the center differential slightly when doing this.
-- Make sure the center differential can be turned by hand.
-- Install the housing with the transmission output shaft with splines installed and a new O-ring onto the center differential. Rotate the housing slightly if necessary.
-- Install the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
-- Fill transfer case with gear oil. Refer to GEAR OIL, DRAINING AND FILLING .