Transmission Fluid Auxiliary Hydraulic Pump, Removing And Installing: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
- Pay attention to the general repair information. Refer to GENERAL REPAIR INFORMATION .
- Pay attention to the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Move the selector lever into "P".
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Carefully disconnect the connector -B- for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A-.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A- from the transmission housing.
- The Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- fits tightly into the transmission housing because of the O-ring -D-.