Overview - MECHATRONIC, 0D5 And 0D6
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Coat O-rings and seals with ATF. Other types of lubrication leads to faults in the transmission control module hydraulics.
- Transmission Fluid Pan
- With integrated ATF filter
- Removing and Installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to MECHATRONIC TIGHTENING SPECIFICATIONS .
- Replace after removing
- Bolt
- 10 Nm
- Wiring Harness
- Depending on the version
- For Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP WIRING HARNESS, REMOVING AND INSTALLING .
- O-Rings
- Replace after removing
- Lock Washer
- O-Ring
- Replace after removing
- ATF Pipe
- Replace after removing
- Connector Housing
- Replace after removing
- Bolt
- 5.5 Nm
- Seals
- Replace together with the connector housing
- O-Rings
- Replace together with the ATF pipe
- Mechatronic
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING, TRANSMISSION GENERATION 2 .
- Hydraulic Pulse Memory or Auxiliary Hydraulic Pump
- Different versions
- Hydraulic Pulse Memory, Removing and Installing. Refer to HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, REMOVING AND INSTALLING .
- Auxiliary Hydraulic Pump, Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing
- For connection for Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Bolt
- Hydraulic pulse memory: 8 Nm
- Additional hydraulic pump: 4 Nm +45°
- Replace after removing
- Quantity: 3
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing
- ATF Drain Plug
- Tighten all the way
- O-Ring
- Replace after removing
Transmission Fluid Pan - Tightening Specification and Sequence (12 Bolts)
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 12- | Install the new bolts by hand until the bolt heads touch |
| 2. | -1 to 12- | 4 Nm |
| 3. | -1 to 12- | 45° additional turn |
Transmission Fluid Pan - Tightening Specification and Sequence (13 bolts)
-- Tighten the bolts in two steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 13- | Install the new bolts by hand until the bolt heads touch |
| 2. | -1 to 13- | 10 Nm |