ATF Cooler, Removing And Installing: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
CAUTION:
Risk of damaging the suspension components.
- Do not rest the vehicle on its wheels if the assembly mounts, the steering gear or the subframe crossbrace are not installed correctly.
-- Place the :SMN372500 under the transmission.
-- Disconnect the ATF lines -1 and 4-. Refer to Figure.
NOTE:
Place a clean cloth under the separating point to catch the escaping coolant.
-- Clamp the coolant hose with the :3094 .
-- Loosen the hose clamps -2 and 3-. Remove the coolant hoses.
-- Remove the bolts -arrows- and remove the ATF cooler.