Brake Pad Wear Indicator Wire, Removing And Installing, RSQ8: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Check the brake pad wear indicator contact for damage and replace if necessary.
- Make sure that the brake pad wear indicator contact fits correctly in the brake pad.
- If the clips go missing, the brake pad wear indicator wire must be replaced.
-- Secure the brake pad wear indicator wire with the protective cap -3- and engage on the brake caliper -arrows- as shown.
-- Insert the contact -1- for the brake pad wear indicator with the clip -2- until it engages in the brake pad.
-- Bring the connector -5- into its installed position and turn in the direction of -arrow- until the tab -2- engages in the opening -1- on the bracket.
-- Connect the connector -4-.