Brake Pad Wear Indicator Wire, Removing And Installing, Q8: Removing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front wheel. Refer to WHEELS AND TIRES .
-- Disconnect the connector -1-.
-- Release the connector -2- from its bracket in direction of -arrow A- while turning it 90° at the same time in direction of -arrow B-.
-- Free up the wire, to do so open the protective cap -3- and disengage the wires from the brake caliper -arrows-.
-- Remove the contact -1- for the brake pad wear indicator from the brake pad. Pay attention to the clip -2- while doing so.