Mounting Bracket, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Disconnect the brake pedal from the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .

Vehicles without High-Voltage System:

Courtesy of AUDI

-- Remove the bolts -arrows-.

Vehicles with High-Voltage System:

Courtesy of AUDI

-- Remove the bolts -arrows-.

Continuation for All Vehicles:

Courtesy of AUDI

-- Disconnect the connector -3- and free up the wire.

-- Remove the nuts -1-.

-- Remove the bolt -2-.

-- Remove the mounting bracket with the brake pedal and accelerator pedal module installed.

-- Remove the brake pedal. Refer to BRAKE PEDAL, REMOVING AND INSTALLING .

-- Remove the accelerator pedal module. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79- / -G185-, REMOVING AND INSTALLING .