Vacuum Pump, Removing And Installing, Vehicle With 3.0L TFSI Engine: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the seal after removal.
- Check the vacuum lines for damage before assembling and replace if necessary.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the appropriate Parts Information.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning in direction of -arrows-.
-- Push the new hose clamp over the vacuum hose.
-- Install the vacuum hose with the hose clamp -1- connected.
-- Install the lower air duct pipe. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .