Brake Fluid Reservoir, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Coat the plugs in the brake master cylinder with brake fluid.

-- Insert the brake fluid reservoir into the plugs in the brake master cylinder.

-- Install the securing pin -arrow-.

Courtesy of AUDI

-- Check if the securing pin is sitting in the brake fluid reservoir mounting tabs and in the brake master cylinder.

-- Connect the connector -2- for the Brake Fluid Level Warning Switch -F34-.

-- Fill the brake fluid reservoir up to the "MIN" mark.

Fig 1: Brake Fluid Reservoir

Courtesy of AUDI

-- Remove all cloths from the vehicle that were previously placed down.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.