Ceramic Brake Rotor Wear, General Information
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
TIP:
- The wear is determined by determining the brake rotor thickness "and" the wear value with the Carbon-Ceramic Brake Wear Tester:VAS6813 ; both must be measured three times respectively around the circumference.
- The permitted brake rotor minimum thickness "min.th." and the wear value -C- are engraved on the brake rotor cup for the Carbon-Ceramic Brake Wear Tester:VAS6813 .
- The wear value -C- is different depending on the brake rotor and the measurement location.
TIP:
- If the brake rotor thickness "min.th." falls short at one measuring point, the brake rotor must be replaced.
- "or"
- If one of the three wear values -C- is reached or falls short when determining the wear using the Carbon-Ceramic Brake Wear Tester:VAS6813 , the brake rotor must be replaced.
- The wear value -C- is different depending on the brake rotor.
If there is abrasion both brake rotors on both sides of the axle must always be replaced.