Clamping Sleeve Installation Position
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Installation Position of the Right Clamping Sleeve
-- Install the clamping sleeve in the position shown.
- Angle -α- = approximately 35°±5°.
- Threaded connection to the right.
- The nuts are toward the top.
Installation Position of the Left Clamping Sleeve
-- Install the clamping sleeve in the position shown.
- Angle -α- = approximately 35°±5°.
- Threaded connections are to the left.
- The nuts are toward the top.