Exhaust Door Control Unit -J883-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the bolts after removing them.
-- Bring the exhaust door control unit into its installed position
- The shaft -2- must engage the groves -arrows- of the exhaust door -1-.
-- If the exhaust door control unit was replaced, perform the adaptations listed in Guided Function "0001 - mechanical engine, functions" using the Vehicle Diagnostic Tester .