Adhesive Surfaces For Adhesive Tape
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle must be at room temperature before installing self-adhesive covers, door seals, etc. with adhesive tape, for example.
- The adhesive surfaces on the body must be free of dust and grease.
- Clean the adhesive surfaces using Cleaning Solution:D 009 401 04 .
- Apply Bonding Agent -D 355 205A2- on the body-side adhesive surfaces using the Applicator -D 009 500 25- and let dry.
- Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air blower.
- After installing, press on the covers with adhesive tape again using a roller.
- After installing, pull on the components by hand to check for a secure fit.