Front Interior Lamp/Reading Lamp, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- The marking shows the position of the springs -arrows-.
- The retainers -1- are removed from the body by prying them out.
-- Remove the interior rearview mirror. Refer to INTERIOR REARVIEW MIRROR, REMOVING AND INSTALLING .
-- Remove the sun visor center support. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .
-- Insert a plastic paint scraper -5- on both the left and right sides between the roof module -3- and the headliner -1- near the side retainer and position it behind the retainer -4- by turning.
- The clip must be pushed in the direction of the roof module.
-- From the front, guide the scraper -2- in between the headliner and body near the retainers.
-- Use the scraper to forcefully push the front roof module out of the roof opening in direction of -arrow- ; the front retainer is pulled out of the body while doing so.
-- Disconnect the connector and free up the wiring harness.