12 V Socket 4 -U20-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Using a narrow screwdriver at the opening -arrow A- release the cap and at the same time push on the bottom slightly upward in direction of -arrow B-.
-- Remove the cap.
-- Remove the bolt -2-.
-- Pivot the button trim -1- out of the mount in direction of -arrow C-.
-- Disconnect the connectors.
-- Remove the nut -2-.
-- Remove the 12 V socket -3- from the luggage compartment side trim panel -1-.
-- Disconnect the connector -4-.
-- If the 12 V socket cannot be removed as described the luggage compartment side trim panel in the area of the 12 V socket must be loosened. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .