Tread Depth, Measuring

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

For this, pay attention to the running surface depth differences. Refer to PERMITTED DIFFERENCES IN TREAD DEPTH .

NOTE:

When measuring tread depth, take measurements in the main grooves.

Do not take measurements at the tread wear indicator.

Tread depth of a tire must be measured in the main grooves at the points showing the most wear. The positions of the tread wear indicators are marked along the tire shoulder.

Fig 1: Locating Tread Wear Indicator

Courtesy of AUDI

In place of "TWI", there may also be a "Δ" or "company emblem".

The TWI protrusions are 1.6 mm tall. This is the minimum tread depth legally prescribed in Germany.

Different values may apply in other countries.

Tread Wear Indicators (TWI) must not be included in the measurement. The deepest point of the groove must be used for the measurement.

Fig 2: Identifying Tread Wear Indicators

Courtesy of AUDI

A - Tread Wear Indicators in Main Tread Grooves

B - Main Grooves with Tread Wear Indicators -arrows-