LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Ignition/Glow Plug System (Servicing - 8-Cylinder 4.0L 4V TFSI Engine Ea825)) >> 28 Ignition/Glow Plug System >> Ignition System >> Engine Speed Sensor -G28-, REMOVING AND INSTALLING >> Removing

Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the (rear) noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 1: After-Run Coolant Pump -V51-
GWWA28-10058Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the Engine Speed Sensor -G28-.

scientia non olet · About LEMON Manuals