Refrigerant Lines With Inner Heat EXCHANGER, Removing And Installing: Removing
Vehicles with High-Voltage System
-- Switch off (deactivate) the "parking air conditioner". Refer to Owner's Manual.
-- Switch the ignition on.
-- Vehicles with Heat Pump Function, initiate the A/C system basic setting through the Thermal Management Control Module -J1024- and open the power-activated valves through the stored routine Extract, evacuate and fill the refrigerant circuit using the Vehicle Diagnostic Tester .
-- Switch off the ignition.
Continuation for all vehicles
-- Discharge the refrigerant circuit. Refer to Refrigerant Circuit or A/C SERVICE STATION, USING .
-- Remove the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
Danger of frostbite due to refrigerant coming out under pressure.
Frostbite on the skin and other parts of the body is possible.
- Wear safety gloves.
- Wear protective eyewear.
- Evacuate or drain refrigerant and open the refrigerant circuit immediately.
- If more than 10 minutes elapse after extracting or draining the refrigerant and the refrigerant circuit has not been opened, extract or drain the refrigerant again. Pressure develops in the refrigerant circuit due to evaporation.
-- Remove the bolt -A-.
-- Remove refrigerant lines -B and C- (in the area under the left headlamp) from refrigerant line with inner heat exchanger -D-.
-- Remove the bolt -A-.
-- Loosen the inner heat exchanger -C- from the bracket -B- and the pass-through -D-.