Bolts And Nuts
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the bolts opposite the tightening sequence.
- Tighten the bolts or the nuts in steps to secure the covers and housings according to the specified tightening sequence and methods.
- Bolts or nuts which secure covers and housings should be loosened and tightened diagonally and in steps if no tightening sequence is specified.
- Always replace self-locking nuts and bolts.
- If not otherwise specified: clean the threads of the bolts which were installed with locking fluid with a wire brush. Then insert the bolts with fluid locking compound. Refer to the Parts Information.
- If self-locking bolts were installed or if regular bolts were installed with locking fluid, then the threaded holes must be cleaned, for example with a thread tap. If the holes are not cleaned, then the bolts could break off the next time they are removed.
- Tightening specifications for non-lubricated bolts and nuts are given.