Overview - Radiator/Radiator Fan
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Radiator
- Coolant Hose
- For vehicles with high-voltage system
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- Radiator
- Removing and Installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- O-Ring
- Check for damage and replace if necessary.
- Coat with coolant
- Plug/Coolant Hose
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Ring
- Check for damage and replace if necessary.
- Coat with coolant
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- Coolant Hose
- To the coolant expansion tank
- To remove, press the release ring
- Connecting. Refer to Fig 2.
- O-Ring
- Check for damage and replace if necessary.
- Coat with coolant
- Rubber Bushing
- For the radiator
- Sleeve
- Retaining Pin
- Disengage and remove using the screwdriver
- Coolant Hose
- For vehicles with high-voltage system
- High-Voltage Coolant Circuit Radiator
- For vehicles with high-voltage system
- Removing and Installing. Refer to HIGH-VOLTAGE COOLANT CIRCUIT RADIATOR, REMOVING AND INSTALLING .
- Coolant Hose
- For vehicles with high-voltage system
- Upper Air Duct
- There are different versions. Refer to the appropriate Electronic Parts Information.
- Removing and Installing. Refer to AIR DUCT, UPPER, REMOVING AND INSTALLING, VEHICLES WITHOUT RADIATOR SHUTTER .
- Side Air Duct
- There are different versions. Refer to the appropriate Electronic Parts Information.
- Removing and Installing. Refer to AIR DUCTS, REMOVING AND INSTALLING .
- Rubber Bushing
- For the radiator
- Rubber Buffer
- Bolt
- 14 Nm
- O-Ring
- For vehicles with high-voltage system
- Check for damage and replace if necessary.
- Coat with coolant
Connect the Connector Coupling
-- Replace the damaged clamp -3-.
-- Check the O-ring -2- or ring -5- for damage. The O-ring can optionally be replaced by the ring. When installing the ring, mind the installation position, the groove points towards the inside.
-- Coat the new O-ring or ring with coolant.
-- Press on the connector coupling -4- to the connection -1- until it engages audibly.
-- Push the connector coupling on again and pull it to make sure the connector coupling is engaged correctly.