Coolant Expansion Tank For Engine Coolant Circuit, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Lift the clamp -2- and remove the breather line -3-.
-- Remove the bolts -arrows-.
-- Remove the coolant expansion tank upward from the bracket -4-.
-- Release and disconnect the connector -1- for the Engine Coolant Level Sensor -G32-.
-- To catch the coolant, place a suitable drip tray under the coolant expansion tank.
-- Clamp off the coolant hose -5- with Hose Clamps - Up To 25mm:3094 .
-- Lift the clip -4-, remove the coolant hose -5- and allow the coolant to drain.
-- Remove the coolant expansion tank.