After-Run Coolant Pump -V51-, REMOVING AND INSTALLING, AUDI Q8, AUDI Q7 FROM PRODUCT IMPROVEMENT: Removing
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Remove the right subframe shield upper section. Refer to SUBFRAME SHIELD, REMOVING AND INSTALLING .
-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
-- Remove the right drive axle from the transmission. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Disconnect the connector -3-.
-- Remove the double bolts -2-.
-- Remove the hose clamps -arrows- and remove the After-Run Coolant Pump -V51- with bracket.
-- Remove the bolts -1- and remove the pump from the bracket.