Part II
WARNING: This page is about a different car, the 2022 Audi Q8, 2021 Audi Q8, 2020 Audi Q8, and 2019 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item ) Part II - List Item: Stud Bolt
- Tensioning Bracket
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut. Refer to -item ) Part II - List Item: Nut
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt. Refer to -item ) Part II - List Item: Stud Bolt
- Oil Return Line
- Replace after removing.
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item ) OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE, VERSION 1 - List Item: Bolt
- Seal
- Replace after removing.
- Air Duct Pipe
- Bolt
- Tightening specification. Refer to -item ) OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE, VERSION 1 - List Item: Bolt
- Seal
- Replace after removing.
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Replace after removing.
- Seal
- Replace after removing.
- Stud Bolt
- 15 Nm
- After loosening, replace the nut ) Part II - List Item: Nut